Software Version; Data Protection; Brightness; Cleaning - TechniSat DIGITRADIO 370 CD IR Mode D'emploi

16.10 Software version

Under Info you can retrieve the currently installed software version.
Press the MENU button and use the / buttons to select the [System
>
Settings] > [Info] item, then press ENTER.
> The current software version is displayed.

16.11 Data protection

Under this option you can find the data protection information.

16.12 Brightness

It is possible to set the display brightness both for operation and standby. There are
also various colour schemes available.
Press the MENU button and use the / buttons to select the [System
>
Settings] > [Brightness] item, then press ENTER.
[Operation] regulates brightness in the normal operating status. You can
choose from [High], [Medium] and [Low] brightness intensities. Use / to
select the brightness level and press ENTER to save.
[Standby] regulates the brightness in standby mode. You can choose from
[Medium] and [Low] brightness intensities here. Use / to select a
brightness level and press ENTER to save.
[Auto Dim] automatically dims the display to the Low brightness level after a
set time without the radio being used.
When the [Off] option is selected, the display will be permanently lit with the
brightness selected under [Operation]. Press ENTER to apply the setting.

17 Cleaning

To prevent the risk of electric shock, you must not clean the device using a wet
cloth or under running water. Prior to cleaning, pull out the mains plug and
switch off the device!
You must not use scouring pads, scouring powder and solvents such as
alcohol or petrol.
Do not use any of the following substances: saltwater, insecticide, chlorine-
based or acidic solvents (ammonium chloride).
Clean the housing using a soft, damp cloth. Do not use spirit, thinners, etc.;
you could damage the surface of the device.
84