Playing Cds; Setting The Track - TechniSat DIGITRADIO 370 CD IR Mode D'emploi

12.3 Playing CDs

> Switch to CD player mode by pressing the MODE button.
[CD] is shown on the display.
>
> Press the EJECT button to open the CD tray.
> Insert the CD with the labelled side facing upwards. Ensure that the CD is not
positioned at an angle.
Press the EJECT button to close the CD tray again.
>
> The data on the CD is scanned. [Reading] appears in the display.
Do not perform any operation until the CD content has been completely read,
to ensure that all the required information on the CD has been read. With MP3
CDs in particular, this process can take some time.
To insert/remove the CD, please hold it by the edge.
> By pressing the Play/Pause
time appears on the display), or continue playback by pressing it again.
> Use the Stop
on the display.
Always stop the playback prior to removing the CD.
If there is no playback, the DIGITRADIO 370/371 CD IR switches to standby
after 15 minutes.

12.4 Setting the track

Use the Previous Track
>
previous track.
With MP3 CDs the display shows the relevant folder [F] and track [T] number
being played.
> Alternatively you can press the numeric keys to jump straight to a track
number.
If there are multiple folders/albums on the MP3 CD, tracks can only be
selected in sequence. Use the F+ and F- buttons to select a specific folder.
72
button, you can pause playback (the playing
button to stop playback. The total number of tracks appears
or Next Track
buttons to skip to the next or