Product Specific Precautions - Franklin Electric SUBDRIVE UTILITY Manuel D'utilisation

SAFETY INSTRUCTIONS

Product Specific Precautions

Product Specific Precautions
High voltages capable of causing severe
injury or death by electrical shock are
present in this unit.
• To minimize risk of electrical shock, disconnect power
before working on or around the system.
• Serious or fatal electrical shock may result from fail-
ure to connect the ground terminal to the motor,
drive, metal plumbing, or other metal near the motor
or cable, using wire no smaller than motor cable
wires.
• Do not use motor in swimming areas.
• Capacitors inside the drive can still hold lethal voltage
even after power has been disconnected—ALLOW 5
MINUTES FOR DANGEROUS INTERNAL VOLTAGE TO
DISCHARGE BEFORE REMOVING COVER.
6
Risk of damage to drive or other equipment.
• Install and wire product according to the instructions
in this manual.
• Take protective measures against ESD (Electrostatic
Discharge) before touching control boards during
inspection, installation or repair.
• This product is recommended for use with Franklin
Electric 4-inch submersible motors as specified in
this manual (Refer to
page 39). Use of this unit with any other Franklin
Electric motor or with motors from other manufac-
turers may result in damage to both motor and elec-
tronics.
• In applications where water delivery is critical, a
replacement pressure sensor and/or back-up system
should be readily available if the drive fails to operate
as intended.
"Common Specifications" on