Electric Connections - RIB IDRO C 27/1B Manuel D'instructions

ELECTRIC CONNECTIONS

rX1-tX1 = EXtErNAL pHotoELEctric cELLs
rX2-tX2 = iNtErNAL pHotoELEctric cELLs
c = cApAcitor
CARRYING OUT THE CONNECTIONS
J1 => L1-N 230Vac 50/60Hz - power supply (on request 120V/60Hz)
J2 => Motor
terminal board for the connection to the motors 1 and 2, u1/u2 =
BLuE wire (common)
Blinker (max. 40W)
J3 => AEriAL radio aerial. connection terminals of the antenna coaxial wire (type
rG5852). NB: See the shield does not come into contact with the
central wire of the cable, since a contact can reduce the action
range of the radio transmitters.
D+D- power supply for accessories – 12Vdc
pHot. Nc photocells contact (Nc – normally closed)
EDGE contact for the safety strips that are active both during opening and
both during closing (n.c.).
K Butt. contact for the single impulse (No – normally open)
coM. common earthing unit for contacts
J5 => rADio radio-frequency module 433.92 MHz (type K2 crX), or connector for
housing the radio receivers rlB supplied with 12Vdc current (type K2,
excepting crX).
J8* => Electric lock 12Vac (max. 15W)
Lsc Limit switch contact stopping the closing cycle M2
Lso Limit switch contact stopping the opening cycle M2
Lsc Limit switch contact stopping the closing cycle M1
Lso Limit switch contact stopping the opening cycle M1
coM common of the contacts
* N.B. The control panel is supplied without the above starred limit switches
contacts. However, these contacts can be supplied on request, but, if they
are not used they must be bridged.


POWER
C
C
G
B