Electric Connections - RIB K1400 FAST Instructions Pour L'utilisation Et L'installation

ELECTRIC CONNECTIONS

ELECTRONIC BOARD KS V.07 FAST
Obligatory software version 07 FAST or following versions FAST.
BC07050
V.07 FAST
A - CONNECTIONS
J1 => EXP. Connector for EXPANDER card
J2 => SEC.TRANSF. Connector for secondary transformer
J3 => L1 - N Power supply 230 Vac 50/60 Hz (on request 120V/60Hz)
J4 => PRI.TRANSF. Connector for primary transformer
J5 => DO NOT TOUCH THE JUMPER !
IF IT IS REMOVED THE OPERATOR DOESN'T MOVE !
J6 => SEC.LOCK Connector to the manual release safety device
J7 => ENCODER - NOT APPLICABLE -
J8 => CAPACITOR Connector to the capacitor
J9 => Connector for limit switch connection
LSO Limit switch contact stopping the motor opening
COM. Contacts common unit
LSC Limit switch contact stopping the motor closing
J10 => MOTOR Connector to the Motor
J11 => Blinker (max. 40W )
J12 => AERIAL Radio Antenna
COM Contacts common unit
PHOT.1 NC Photocells contact (NC)
J13 => INVERTER - NOT APPLICABLE -
J14 => STOP Contact of the stop button (NC)
OPEN Contact of the opening button (NO)
CLOSE Contact of the closing button (NO)
K BUTT. Contact of a single impulse (NO)
A*A 24 Vac accessories power supply
SIGNAL Warning light - gate open 12Vdc
Buzzer - Wiring acoustic warning (12Vdc max 200 mA)
J15 => RADIO Connector for radio receiver 24Vac
J16 => HEATER Connector for Heater Card
J17 => INVERTER - NOT APPLICABLE -
R2 => TRIMMER LOW SPEED to adjust the speed of the deceleration, both in opening
and closing
R9 => TRIMMER FOR TORQUE to adjust the force of the operator through the
electronic clutch
Pag. 23 di 40
E
N
G
L
I
S
H