Control Panel - Jacuzzi SPA MAXI-PREMIUM J-210 Manuel D'installation Et Utilisation Et Entretien

6
5
2
WARNING!
Do not get in the spa until the quantity of disinfectant has not
dropped below the level recommended by the manufacturer
and/or by your retailer.
Always check water temperature carefully before entering spa.

Control Panel

A Display: can display current water temperature, water tem-
perature set point, selected skimming/heating mode, and error
messages.
B. ( + ) Button: increases water temperature set point.
C. ( - ) Button: decreases water temperature set point.
The range of temperature adjustment goes from 18 to 40 °C.
Factory default setting is 38 °C.
D. Light button: switches the underwater light on and off.
Activates the LED lighting system, if present.
The light stays on for an hour and then switches off so that the
light bulb will last longer.
E. Pump 1 button: turns pump 1 on and off. Press once for low
speed; press a second time for high speed; press a third time to
turn pump off.
F. Pump 2 button (only for models with two pumps): turns
pump 2 on and off. Press once to turn it on; press twice to turn
the pump off.
The jets operate for 20 minutes after activation; then they switch
9
7
1
Flow
4
3
E C
F D
1 1
2 2
D E
A A
B G
C G
F B
1 Electrical box
2 Power supply entrance(s)
3 2-Speed Pump (pump 1)
4 Heater
5 Pump drain plug(s)
8
6 1-Speed pump (pump 2)
7 Ozonator (optional)
8 Injector (optional, required for Ozonator)
9 Display
5
2
off automatically to conserve energy. Simply press either jets
button to continue operation for an additional 20 minutes.
G. Heat Indicator: lit when heater is on.
18