Circulation Pump; Control Panel - Jacuzzi J-300 Manuel D'installation Et Utilisation Et Entretien

7
2
6
Turning on power
Turn on power to spa at the home's circuit breaker: the heater
and circulation pump automatically activate. The water temper-
ature LED flash on the control panel and the messages "COOL" or
"ICE" appear.
Note: "COOL" and "ICE" will only appear when the spa is in Econ-
omy mode.
Start-up
Activate the pump(s). (see "control panel")
NB: do not start the pump(s) if the water does not cover the high-
est pump nozzles.
- Open all of the air controls and turn all of the massage selector
knobs to the central position.
Addition of chemical additives at first start-up
Please refer to the Jacuzzi system water treatment guide and
relative catalogue for details on water quality maintenance, the
methods and warnings governing the use of relative chemical
products.
CAUTION: Read and follow all the instructions related
to the use and storage methods of chemical products,
in strict compliance to the manufacturer's instructions
provided on the packaging.
CAUTION! Do not use trichlorine tablets! This can dam-
age the components of the hot tub and cause burning
and irritation to the skin and mucous membranes. The
use of these chemicals will void the manufacturer's
warranty.
N.B.: Always cover the spa (except when mixing chemical addi-
tives!) with the insulating cover, so as to reduce heating times and
thus minimize operating costs.
The time required for initial heat-up will vary depending on the start-
ing water temperature.
9
11
8
10
1
3
6
4
5
1 Electrical box
2 Power supply entrance(s)
3 1 Speed Pump
4 Heater
5 Drain valve
6 Pump drain plug(s)
7 1-Speed pump
8

Circulation pump

9

Control Panel

2
10 CLEARRAY™ (Ultraviolet) Water Purification Sy-
stem
11 Optional ProLink™ Monitoring System
WARNING!
Do not get in the spa until the quantity of disinfectant has
not dropped below the level recommended by the manufac-
turer and/or by your retailer.
Always check water temperature carefully before entering spa.
32