Control Functions; Control Panel - Jacuzzi J-200 Serie Mode D'emploi

J-200
9.0

Control Functions

9.1

Control Panel

A. LED Display: Can
display current water
temperature (default
display), water tem-
perature set point,
selected filtration/heat-
ing mode, and error
messages.
B. Heat Indicator: Lit when heater is on.
C. Jets 1 Button: Turns jets pump #1 on and off. Press once for low
speed; press a second time for high speed; press a third time to turn
pump off.
D. Jets 2 Button: Turns high-speed jets pump #2 on and off. Press
once to turn pump #2 on; press a second time to turn pump #2 off.
E. Light Button : Turns underwater light (if equipped) and accent lights
on in one of three random modes or one of seven solid colors. Refer
to Section 10.3 (page 26) for details.
F. Warmer (
G. Cooler ( ) Button: Decreases water temperature set point.
Operation Details
• Temperature Adjustment: 65 to 104°F (18 to 40°C). Factory default
setting is 100°F (38°C).
• LED light system: All LED lights run for 1 hour and then automatically
shut off.
• Jets 1/Jets 2 Button Operation: Jets run for 20 minutes when
activated, then turn off automatically to conserve energy. Simply
press either jets button to continue operation for an additional 20
minutes.
22
) Button: Increases water temperature set point.
C
D
1
E
2
A
B
G
F