Control Panel - Jacuzzi J-300 Manuel D'installation, D'utilisation Et D'entretien

7
2
6
I
Addition of chemical additives at first start-up
Please refer to the Jacuzzi system water treatment guide and rela-
tive catalogue for details on water quality maintenance, the methods
and warnings governing the use of relative chemical products.
N.B.: Always cover the spa (except when mixing chemical
additives!) with the insulating cover, so as to reduce heating
times and thus minimize operating costs.
The time required for initial heat-up will vary depending on the
starting water temperature.
WARNING!
Do not get in the spa until the quantity of disinfectant has not
dropped below the level recommended by the manufacturer
and/or by your retailer.
Always check water temperature carefully before entering spa.

Control Panel

B
A
C D
Control panel for models with 2 pumps.
A. CLEARRAY™ (
CLEARRAY™ system for a one-hour period.
B. CLEARRAY™ Indicator Light: Lit when the CLEARRAY™
system is on. Flashing when the UV bulb needs to be replaced.
C. Light On/Off ( ) Button Options: Turns waterfall light,
footwell light, lighted cup holders and backlit pillows on in uni-
son. Press once for high intensity; press a second time for medi-
um intensity; press a third time for low intensity; press a fourth
time to turn off. The displayed color is changed using the light
mode button (D) below.
11
4
1
3
10
8
K
J
I
E F
G
1 2
) Button: Manually activates the
1 Electrical box
2 Power supply entrance(s)
3 1 Speed Pump (pump 1)
4 Heater
5 Drain valve
6 Pump drain plug(s)
7 1-Speed pump (pump 2)
9
8 Circulation pump
2
9 CLEARRAY™ (Ultraviolet) Water Purification System
5
6
10 Electronic Ballast (for the
11 Display
D. Light Mode (
modes for waterfall, footwell, cup holders, and pillow lights.
E. Cooler (
point. Also used to navigate through the programming menus.
F. Warmer (
point. Also used to navigate through the programming menus.
G. Jets 1 (
once to turn pump #1 on; press a second time to turn pump #1
off.
H. Jets 2 (
off. Press once to turn pump #2 on; press a second time to turn
pump #2 off.
I. Menu (
menus.
J. Heat Indicator: Lit when heater is on.
K. LED Display: Can display current water temperature (default
display), water temperature set point, selected menu functions,
and error messages.
Operation Details
Temperature Adjustment: 65 to 104°F (18 to 40°C). Factory
H
default setting is 100°F (38°C).
CLEARRAY™ Operation: System runs for 1 hour (when manu-
ally activated), then automatically shuts off.
Light Operation: All LED lights run for 2 hours, then automati-
cally shut off.
Jets 1/Jets 2 Button Operation: Jets run for 20 minutes when
activated, then turn off automatically to conserve energy. Sim-
ply press either jets button to continue operation for an additional
20 minutes.
24
CLEARRAY™
) Button: Selects one of 4 light color
) Button: Decreases water temperature set
) Button: Increases water temperature set
) Button: Turns jets pump #1 on and off. Press
) Button (J-385): Turns jets pump #2 on and
) Button: Allows access to the programming
System)