Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

20 progress
Filling the rinse aid dispenser

DAILY USE

1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to 'Setting and
starting a programme'.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
Using the detergent
A
B
30
20
Setting and starting a programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
Press the on/off button to activate the ap-
pliance. The appliance is in setting mode
when all the programme indicators come
on and the display shows 2 horizontal sta-
tus bars.
If the control panel does not show this con-
dition, press and hold at the same time but-
A
B
A
-
+
C
D
A
+
-
C
1. Press the release button (D) to open
the lid (C).
2. Fill the rinse aid dispenser (A), no more
than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the re-
leased quantity (B) between position 1
(lowest quantity) and position 4 (high-
est quantity).
3. Load the baskets.
4. Add the detergent.
• If you use the combi detergent tab-
lets, activate the Multitab option.
5. Set and start the correct programme for
the type of load and the degree of soil.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appliance
door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
ton
and button
ance is in setting mode.
Starting a programme without delay
start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode.
3. To set a programme, keep the appli-
ance door ajar.
until the appli-

Publicité

Table des Matières
loading

Table des Matières