Troubleshooting - Progress PIX1540X Notice D'utilisation

Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.

TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to the
information that follows for a solution to the
problem.
With some problems, the display
shows an alarm code:
•
- The appliance does not fill with wa-
ter.
Problem
You cannot activate the appliance.
The programme does not start.
2. To disassemble the filter (A), pull apart
3. Remove the filter (B).
A1
4. Wash the filters with water.
5. Before you put the filter (B) back, make
A2
6. Make sure that the filter (B) is correctly
7. Assemble the filter (A) and put it back
Internal cleaning
If you regularly use short duration pro-
grammes, these can leave deposits of
grease and limescale inside the appliance.
To prevent this, we recommend to run long
duration programmes at least 2 times per
month.
•
•
Make sure that the mains plug is connected to the
mains socket.
Make sure that there is not a damaged fuse in the fuse
box.
Make sure that the appliance door is closed.
(A1) and (A2).
sure that there are no residues of food
or soil in or around the edge of the
sump.
positioned under the 2 guides (C).
in filter (B). Turn it clockwise until it
locks.
An incorrect position of the filters can
cause bad washing results and dam-
age to the appliance.
- The appliance does not drain the
water.
- The anti-flood device is on.
Warning! Deactivate the appliance
before you do the checks.
Possible solution
progress 23