Daily Use - Progress PV3572 Notice D'utilisation

14 Progress
How to fill the rinse aid
dispenser
CAUTION! Only use rinse aid
designed specifically for
dishwashers.

DAILY USE

1. Open the water tap.
2. Press and hold
is activated.
3. Fill the salt container if it is empty.
4. Fill the rinse aid dispenser if it is
empty.
5. Load the baskets.
6. Add the detergent.
7. Select and start a programme.
8. Close the water tap when the
programme is complete.
Using the detergent
A B
1. Press the release button (B) to open
the lid (C).
A B
A
-
+
C
D
until the appliance
C
1. Press the release button (D) to open
the lid (C).
2. Pour the rinse aid in the dispenser (A)
until the liquid reaches the fill level
'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent excessive
foam formation.
4. Close the lid. Make sure that the
release button locks into position.
You can turn the selector of the
released quantity (B) between
position 1 (lowest quantity) and
position 4 or 6 (highest
quantity).
2. Put the detergent, in powder or tablets,
in the compartment (A).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the
release button locks into position.
How to select and start a
programme
1. Press the button dedicated to the
programme you want to set.
The light related to the button flashes.
2. Activate Extra power if desired.
3. Close the appliance door to start the
programme.
How to select and start the
programme Pre Rinse
1. To select Pre Rinse, press and hold
30min for 3 seconds.
The light related to the button flashes.
Extra power is not applicable to
this programme.
2. Close the appliance door to start the
programme.