Available Accessories; Technical Specifications - Metabo HC 260 C WNB Notice Originale

 Make several passes at less
depth of cut.

11. Available Accessories

For particular jobs you will find the follow-
ing accessories at your specialist dealer -
the images can be found at the beginning
of these operating instructions:
A Extraction adapter
For connection to a chip extraction
unit

12. Technical Specifications

Motor 50 Hz
Voltage
Fuse protection
No-load speed
Motor
Cutterblock
Feed rate, thickness planing
Planer knife dimensions
length
width
thickness
Machine dimensions
length (overall across infeed and outfeed table)
width
height
Machine: complete with packaging
Machine: ready for operation
Noise emissions during surface planing according to EN 61029-1 *
Emission sound pressure level L
Sound pressure level L
Measurement uncertainty K
Noise emissions during surface planing according to EN 61029-1 *
Emission sound pressure level L
Sound pressure level L
Measurement uncertainty K
Work piece dimensions
max. width
max. height (thickness planing)
* The values stated are emission values and as such do not necessarily constitute values which are safe for the workplace. Although
there is a correlation between emission levels and environmental impact levels, whether further precautions are necessary cannot be
derived from this. Factors influencing the actually present environmental impact level in the workplace include the characteristics of
the work area and other noise sources, i.e. the number of machines and other neighbouring work processes. Also, permissible work-
place values may vary from country to country. This information is intended to assist the user in estimate of hazards and risks.
B Three- roll stand
For precise guidance of long work
pieces
C Planer knives
For planing of wood pieces (can be
resharpened)
D Planer knives
For planing of wood pieces
E Planer knives
For planing of wood pieces (car-
bide, can be resharpened)
(under load)
pA
(under load)
WA
WA
(under load)
pA
(under load)
WA
WA
F Cutter bar conversion set
For retrofitting the planer knives
G Planer knife setting device
For problem-free setting of the knife
projection.
H Lubricant WAXILIT
For good sliding quality of the wood
on the support table
I Maintenance and care spray
For the removal of resin residue and
for preservation of metal surfaces
HC 260 C
WNB
W 2200
V 230
A 16
-1
min 2700
-1
min 6500
m/min 5
mm 260
mm 18.6
mm 1
mm 1110
mm 575
mm 940
kg 76.0
kg 71.0
dB (A) 84.1
dB (A) 91.3
dB (A) 3
dB (A) 87.6
dB (A) 94.1
dB (A) 3
mm 260
mm 160
ENGLISH
en
HC 260 C
DNB
2800
400
16
2700
6500
5
260
18.6
1
1110
575
940
76.0
71.0
84.1
91.3
3
87.6
94.1
3
260
160
27