Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8
Marking and drilling the
STEP
glass shelf holes
Place the template in the corner of the shower where
you want to install your shelf.
Slide the template up until the points on the left and
right-hand side of the template are at the height you
want your shelf.
Use a pencil, marker or wax pencil to mark the spots
where the holes for the shelf will be drilled.
Drill the holes using a 9/64" drill bit.
Drilling positions
9
Silicone
STEP
Apply a bead of silicone all along the wall to wall
and wall to base joints. For a smooth finish you can
remove the silicone excess with a damp rag or wet
finger.
Apply masking tape on both sides
Quick tip
of the joint where you will run a
bead of silicone. Apply the silicone,
smooth with a wet finger then
remove the masking tape.
Fold here
remove protective film from walls
Check me!
90°
Check me!
all faucets installed on the walls
must be sealed with silicone.
15
Publicité
Table des Matières
