Maintenance; Environmental Protection; Available Accessories - Promac JDT-2512V Mode D'emploi

5. The work table must be locked to
the column so it will not be forced
down the column.
6. Before drilling, release the quill
lock nut to permit free travel of the
quill.
7. Be sure the belt is tightened to the
proper tension.
8. DO NOT start to drill the work piece
until making certain the work piece
is held down securely.
9. Make sure the power being off
when changing the belt for shifting
speed.
10. Point of operation protection is
required for maximum safety. This
remains the responsibility of the
user/purchaser since conditions
differ between jobs.
11. Make sure the drill is secured in the
spindle or chuck before attempting
to use the drill press.
12. Make sure the spindle taper is
clean and free of burrs, scoring,
and galling to assure maximum
gripping.
13. Lock the quill in position when
using any side-loaded tool.

9. Maintenance

Lubrication and Routine
Maintenance
Apply oils to the driving parts of the
machine prior to operation and supply
coolant during operation to ensure
stability of cutters and the object being
processed. Please refer to the
lubrication as below for more details
about use oil. To extend your machine
life, please make a maintenance
schedule daily, weekly, monthly or
semi-annual and annual. Neglecting the
machine maintenance will result in
premature wear and poor performance.
1. Lubrication
I. Lubricate - Column, Quill. Use
machine tool oil with light film
of oil.
II. Grease - Rack on the column
so that the worktable can
move up/down smoothly. Use
SAE 20 oil. To clean rack with
kerosene before applying oil.
Daily Maintenance
2.
Make a general cleaning by
removing dust and shavings from
the machine.
Check that the shields and
emergency stops are in good
working order.
After daily use, disconnect
machine from power source or
press emergency stop switch to
shut off the power completely. Do
not keep the machine connected
over 24 hours, it may cause
damage to the machine.
3. Weekly Maintenance
Clean the machine.
4. Monthly Maintenance
Lubricate machine column, spindle
and rack devices.
Check that all screws on the motor
and the guard are tight and
secured on the right position.
5. Annual Maintenance
Replace the driving belt by using:
460J for JDT-2512V,
530J for JDT-3216V.
6. Oils for Lubricating Coolant
Considering the vast range of
products in the market, the user
can choose the one most suited to
their own requirements, using as
reference the type SHELL LUTEM
OIL ECO.
The minimum percentage of oil
diluted in water is 8~10%.
7. Oil Disposal
Oil products must be disposed in a
proper manner following local
regulations.
8. Special Maintenance
Special maintenance operations
must be carried out by skilled
personnel. However, we advise
contacting dealer and/or importer
the term special maintenance also
covers the resetting of protection
and safety equipment and devices.

10. Environmental protection

Protect the environment.
Your appliance contains valuable
materials which can be recovered or
recycled. Please leave it at a
specialized institution.
This symbol indicates separate
collection for electrical and electronic
equipment required under the WEEE
Directive (Directive 2012/19/EC) and is
effective only within the European
Union.

11. Available accessories

Refer to the PROMAC-Pricelist for
various accessories.