Steering Wheel Height; Roll Bar; Safety Frame (Roll-Bar Or Rops); Safety Belts (Where Applicable) - GOLDONI STAR 50 Série Mode D'emploi Et D'entretien

Regulating lift rate and sensitivity
Slacken off completely regulating screw n.16 fig.1, to lock the implement in its
raised position. This is a safety device when implements are transported on
road.
Screw out this regulator to increase lift lowering speed.
3-point hitch sensitivity can be further increases by attaching it to one of the
lower tractor hitch holes.
The 3-point hitch must NOT be used to tow implements.

4.9 STEERING WHEEL HEIGHT

The steering wheel can be adjusted in height. Using the lever N° 5 fig.2
• release the safety retainer
• adjust the height
• lock the safety retainer
The steering wheel height must be adjusted with the machine at a
standstill, the engine off and the parking brake engaged.

5. ROLL BAR

5.1 SAFETY FRAME (roll-bar or ROPS)

The machine is equipped with a folding safety frame. Always keep the safety
frame mounted in its correct vertical position when you are working. It is
absolutely forbidden to modify the structural components of this type of
construction by welding on additional parts, drilling holes, grinding, etc. Failure to
comply with these recommendations could impair the rigidity of the frame itself.
The safety frame is subjected to considerable stress if the tractor tips over. If this
happens, the structural components must be replaced if they have been bent,
deformed or damaged in some other way.
When in the horizontal position, the safety frame will provide no
protection if the tractor tips up. When working in these conditions,
it is of the utmost importance for the operator to pay the greatest attention
when manoeuvring the machine.

5.2 SAFETY BELTS (where applicable)

Wear the safety belts when you use the machine with the safety frame (roll-bar
or ROPS) to reduce the risk of accidents if the tractor tips up.
Do not wear the seat belt if you use the machine with the roll-bar
in the horizontal position.
71