Medtronic DBS Patient programmer Manuel D'utilisation page 128

Problems
Fluid on the patient
programmer
Fluid was spilled
onto the patient
programmer or the
patient programmer
was dropped into
water.
128
English 37642 2015-04
Table 6.4 Troubleshooting problems
(continued)
Causes and actions
The patient programmer is not
waterproof, and water can
damage the device.
Immediately remove the
patient programmer from the
water, then dry with a soft
towel.
Remove the batteries, then
allow the battery
compartment to air dry at
room temperature for 24
hours.
Note: If you need to check your
rechargeable neurostimulator
battery while your patient
programmer is drying, you can
use the recharger device.