Securing The Lid Stopper; Attaching The Lid Handle; Securing The Chimney - Pit Boss 700T1 Mode D'emploi

4. SECURING THE LID STOPPER

Parts Required:
1 x Lid Stopper (#9)
Installation:
• Secure the Lid Stopper onto the top of the main barrel using the pre-
installed screw on the top of the main barrel.

5. ATTACHING THE LID HANDLE

Parts Required:
1 x Lid Handle (#10)
2 x Lid Handle Bezel (#11)
Installation:
• Remove the pre-installed screws from the Lid Handle. From inside the
barrel lid, insert one screw to protrude to the outside. Add a bezel on
the screw, then hand-tighten the screw (from the inside) into the Lid
Handle. Repeat same installation for other end of Lid Handle.

6. SECURING THE CHIMNEY

Parts Required:
1 x Chimney Cap (#4)
1 x Chimney Stack (#5)
1 x Chimney Gasket (#6)
2 x Screw (#A)
2 x Washer (#B)
2 x Locking Washer (#C)
Installation :
• Locate the chimney opening on the side of the Main Barrel. From the
outside of the Main Barrel, secure the Chimney Gasket and Chimney
Stack to the side panel using two screws, locking washers, and
washers. The screw will fasten to the pre-mounted nut on the inside
of the barrel.
• Next, secure the Chimney Cap onto the top of the Chimney Stack as
shown.
NOTE: Adjust the Chimney Cap to affect the airflow inside the main
grill. If cooking at low temperature, keep the cap more open. Ensure
the Chimney Cap allows for air to escape.
4
9
5
10
11
6
6
11
4
5
9