Installing The Bottom Shelf; Securing The Lid Stopper; Assembling The Lid Handle; Placing The Grease Bucket - Pit Boss PB820FB Instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. INSTALLING THE BOTTOM SHELF

Parts Required:
1
x
Bottom Shelf (#14)
4
x
Screw (#A)
Locking Washer (#C)
4
x
Washer (#B)
4
x
Installation:
From underneath, secure the bottom shelf to all each leg using a
screw, locking washer, and washer. Ensure the flat surface of the shelf
is facing up.
Once the shelf is secure, carefully lift the grill into an upright position.

3. SECURING THE LID STOPPER

Parts Required:
1
x
Lid Stopper (#3)
Installation:
Secure the lid stopper onto the top of the main barrel using the pre-
installed screw on the top of the main barrel.

4. ASSEMBLING THE LID HANDLE

Parts Required:
1
x
Lid Handle (#10)
2
x
Lid Handle Bezel (#9)
Installation:
Remove the pre-installed screws from the lid handle. From inside the
barrel lid, insert one screw to protrude to the outside. Add a bezel on the
screw, then hand-tighten the screw (from the inside) into the lid handle.
Repeat same installation for other end of lid handle.

5. PLACING THE GREASE BUCKET

Parts Required:
Grease Bucket (#13)
1
x
Installation:
Place the grease bucket on the spout hook on the end of the main
barrel. Ensure it is level to avoid grease spills.
8
2
3
4
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

71820fb

Table des Matières