Mounting The Legs To The Main Barrel; Installing The Bottom Shelf - Pit Boss 700T1 Mode D'emploi

2. MOUNTING THE LEGS TO MAIN BARREL
Parts Required:
1 x Main Barrel (#12)
2 x Stationary Leg (#15)
2 x Leg with Wheel Axle (#16)
16 x Screw (#A)
16 x Washer (#B)
16 x Locking Washer (#C)
Installation:
• Place a piece of cardboard on the floor to prevent scratching the unit.
Lay the main barrel on its side, hopper end pointed upward, on the
cardboard. Note illustration.
• Mount one leg with wheel to the floor end of the main barrel using
four screws, locking washers, and washers, through the four pre-
drilled holes. Repeat installation for second leg with wheel.
• Mount one stationary leg to the hopper end of the main barrel using
four screws, locking washers, and washers, through the four pre-
drilled holes. Repeat installation for second stationary leg.

3. INSTALLING THE BOTTOM SHELF

Parts Required:
1 x Bottom Shelf (#20)
4 x Screw (#A)
4 x Washer (#B)
4 x Locking Washer (#C)
Installation:
• From underneath, secure the bottom shelf to all each leg using a
screw, locking washer, and washer. Ensure the flat surface of the shelf
is facing up.
• Once the shelf is secure, carefully lift the grill into an upright position.
8
2
12
15
15
16
16
B
C
A
3
20
B C A