Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. SECURING THE LID STOPPER
Parts Required:
1
x
Lid Stopper (#4)
Installation:
•
Secure the lid stopper onto the top of the main barrel using the
pre-installed screw on the top of the main barrel.
4. INSTALLING THE HOPPER TO THE BARREL
Parts Required:
1
x
Hopper Assembly, Drop Chute Plate and Screw (#9)
1
x
Probe Wire Casing (#6)
Screw (#A)
4
x
Locking Washer (#B)
4
x
4
x
Washer (#C)
1
x
Power Cord Bracket (#5)
Installation:
•
Secure the drop chute screw to the drop chute plate, and insert into
the horizontal slit on the rear side of the hopper.
•
Align the fire pot end of the hopper assembly into the opening on the
end of the main barrel. Insert only half-way, then carefully slide the
hopper assembly completely into the opening on the end of the main
barrel. Secure the hopper assembly to the main barrel, from the inside
of the barrel, using four screws, locking washers, and washers. Take care
not to over-tighten to avoid stripping the screws. Note illustration 4A.
•
On the rear side of the hopper, connect the silver grill probe
temperature wires – extruding from the main barrel – to the wire
connections from the rear of the hopper assembly. Remove the
two pre-mounted screws. Tuck the excess wire into the probe wire
casing, placing the wire distinctly in the divet along the edge to avoid
pinching. Next, secure the probe wire casing to the hopper using the
two screws previously removed. Note illustration 4B.
IMPORTANT: Ensure the grill probe temperature wires do not get
pinched. Damage to the grill probe temperatures wires may result in
incorrect readings, or inability to funtion.
•
Secure the power cord bracket using the two screws pre-installed on the
rear side of the hopper, above the drop chute plate. Note illustration 4C.
5. ASSEMBLING THE HANDLES
Parts Required:
1
x
Lid Handle (#11)
2
x
Barrel Handle (#11)
Handle Bezel (#10)
4
x
Installation:
•
Remove the pre-installed screws from the lid handle. From inside the
barrel lid, insert one screw to protrude to the outside. Add a bezel on
the screw, then hand-tighten the screw (from the inside) into the lid
handle. Repeat for the other side. Note illustration 5A.
8
3
4A
REAR VIEW
A
C B
4B
4C
5A
Publicité
Chapitres
Table des Matières
Dépannage
