Overhead Rigging - Briteq BTX 2R BEAM Mode D'emploi

ENGLISH
 First push the lamp GENTLY down.
 Now tilt the lamp GENTLY towards you (see arrow on Fig. 4)
With these 2 actions you should be able remove the lamp.
If you cannot remove the lamp, please check if it is not
jammed: eventually change the position of the lamp a little as
explained in Fig.3
 Think of wearing gloves to avoid direct contact with the lamp!
 Insert the new lamp and push it GENTLY down.
Important: ONLY use an original "Philips MSD Platinum 2R"
lamp, other lamps could result in less performance or even
damage the unit.
 Now tilt the lamp GENTLY in place (see arrow on Fig. 5)
 Place the cable on the terminals of the new lamp, make sure
that the connection is tight.
Attention: be sure that the wires don't touch the lamp.
 Switch the unit back on and use a DMX controller to point the
open beam on a wall.
Attention: avoid looking at light coming directly from the
lamp inside the unit, the UV-radi
harmful for your eyes. (the light of the beam passes through
a UV-filter first)
 You will see a hotspot in the beam projected on the wall.
Adjust this hotspot using the screw as shown in Fig. 6. The
hotspot should be as much as possible in the center of the
beam.
 Close the cover
 Done

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
BRITEQ
®
ation of the lamp is
5/78
OPERATION MANUAL
BTX-BEAM 2R