Special Functions; Overhead Rigging - Briteq BTX-FALCON Mode D'emploi

ENGLISH

Special Functions

This submenu contains some useful functions for servicing.
 Press the MENU button and select the "Special Functions" submenu.
Factory Settings
This is your emergency exit if you really messed up the settings: just return to factory settings.
No: keep the current settings unchanged.
Yes: return to factory settings, personal settings are lost.
 Select "Factory Settings" and press ENTER
 Use DOWN / UP buttons to select Yes or No.
 Press the ENTER button to save.
To return to a previous menu, press the MENU button.
OFFSET ADJUST:
Used to adjust the home position of pan / tilt and zoom so
all units are perfectly aligned:
 If you're not already in the setup menu, just press the
MENU button shortly to enter the setup menu
 Now press the ENTER button for at least 5 seconds to go
into offset mode.
 Use DOWN / UP buttons to select one of the available
options.
 Press the ENTER button, the display shows the actual
offset value.
 Use DOWN / UP buttons to adjust the offset values
 Press the ENTER button to confirm your setting or press the
MENU button to leave without saving the value.
To return to normal working mode: press the MENU button.

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12 times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
BRITEQ
®
9/79
OPERATION MANUAL
BTX-FALCON