Fixture Test; Fixture Information - Briteq BTX 2R BEAM Mode D'emploi

ENGLISH OPERATION MANUAL
Contrast Ratio
Select Contrast ratio, press ENTER button to confirm, current mode will blink on the display, use UP and
DOWN buttons to adjust contrast ratio from 1 (low) to 30 (high), press ENTER button to store. Press the
MENU button to go back to the last menu, if you leave the unit unused for one minute it will automatically exit
from menu mode.
Temperature Unit
Select Temperature Unit, press ENTER button to confirm, current mode will blink on the display, use UP
and DOWN buttons to select C° or F°, press ENTER button to store. Press the MENU button to go back to
the last menu, if you leave the unit unused for one minute it will automatically exit from menu mode.
Display Warning
Select Display Warning, press ENTER button to confirm, current mode will blink on the display, use UP and
DOWN buttons to select No (display does not show the warning when the unit goes wrong) or Yes (display
will show the warning when unit goes wrong), press ENTER button to store. Press the MENU button to go
back to the last menu, if you leave the unit unused for one minute it will automatically exit from menu mode.

Fixture Test

Enter menu mode, select Fixture Test, press
ENTER button to confirm, use UP and DOWN
buttons to select Auto Test or Manual Test
Auto Test
Select Auto Test, press ENTER button to
confirm, the unit will run built-in programs to
automatically test pan, tilt, color, gobo, gobo
rotation, shutter, dimmer, prism, prism rotation,
focus, and lamp on/off. Press MENU button back
to the last menu or exit menu mode after auto
test.
Manual Test
Select Manual Test, press ENTER button to
confirm, the current channel will show on the
display, use Up and DOWN buttons to select
channel, press ENTER button to confirm, then
use UP and DOWN buttons to adjust the value,
press ENTER button to store, the fixture will run
as the channel value indicates. Press the MENU
button to go back to the last menu, if you leave
the unit unused for one minute it will
automatically exit from menu mode. (All channel
values will become 0 after exiting Manual Test
menu)

Fixture Information

Enter menu mode, select Fixture Information, press ENTER button to confirm, use UP and DOWN buttons
to select Fixture Use Time, Lamp On Time or Firmware Version.
Fixture Use Time
Select Fixture Use Time, press ENTER button to confirm, fixture use time will show on the display, press
MENU button to exit.
Lamp On Time
Select Lamp On Time, press ENTER button to confirm, lamp on time will show on the display, press ENTER
button to confirm, use UP and DOWN buttons to select Exit or Reset Time, press ENTER button to confirm.
Press the MENU button to go back to the last menu, if you leave the unit unused for one minute it will
automatically exit from menu mode.
Firmware Version
BRITEQ 10/78 BTX-BEAM 2R
®