Lamp Setting - Briteq BTX 2R BEAM Mode D'emploi

ENGLISH OPERATION MANUAL
(pan/tilt will feedback if they are out of step.),
press ENTER button to store. Press the MENU
button to go back to the last menu, if you leave
the unit unused for one minute it will
automatically exit from menu mode.
BL.O. P/T Moving (Blackout while pan/tilt
moving)
Select BL.O. P/T Moving, Press ENTER button
to confirm, current mode will blink on the display,
use UP and DOWN buttons to select No (normal
while pan/tilt are moving) or Yes (blackout while
pan/tilt are moving), press ENTER button to
store. Press the MENU button to go back to the
last menu, if you leave the unit unused for one
minute it will automatically exit from menu mode.
BL.O. Color Change (Blackout while change
color)
Select BL.O. Color Change, press ENTER
button to confirm, current mode will blink on the
display, use UP and DOWN buttons to select No
(normal while the color is changing) or Yes
(blackout while the color is changing), press
ENTER button to store. Press the MENU button
to go back to the last menu, if you leave the unit
unused for one minute it will automatically exit
from menu mode.
BL.O. Gobo Change (Blackout while change
gobo)
Select BL.O. Gobo Change, press ENTER
button to confirm, current mode will blink on the
display, use UP and DOWN buttons to select No
(normal while gobo is changing) or Yes (blackout
while gobo is changing), press ENTER button to
store. Press the MENU button to go back to the
last menu, if you leave the unit unused for one
minute it will automatically exit from menu mode.

Lamp Setting

Enter menu mode, select Lamp Setting, press
ENTER button to confirm, use UP and DOWN
buttons to select On/Off, State/Power on, Off
Via DMX, On if DMX on, Off if DMX off,
Cooling Mode, Ignition Delay or Low Power
Delay
On/Off (Turn on/off the lamp)
Select On/Off, press ENTER button to confirm,
current mode will blink on the display, use UP
and DOWN buttons to select On (lamp on) or Off
(lamp off), press ENTER button to store. Press the MENU button to go back to the last menu, if you leave the
unit unused for one minute it will automatically exit from menu mode.
State/Power On (Lamp state while power on)
Select State/Power On, press ENTER button to confirm, current mode will blink on the display, use UP and
DOWN buttons to select On (Lamp strike during the startup reset) or Off (Lamp is off at the startup), press
ENTER button to store. Press MENU button back to the last menu or let the unit idle one minute to exit menu
mode.
BRITEQ 8/78 BTX-BEAM 2R
®