Tools And Aids - Conrad REELY ROAD Hotlander Next Generation Pro S18 1:10 GP Monstertruck Notice D'emploi

Our advice: Degrees of heat of glow plugs
Standard glow plugs for fuels with nitro methane additive (approx. 5 %)
Cold glow plugs for fuels with nitro methane additive (approx. 10 %)
Super cold glow plugs for fuels with nitro methane additive (more than 10 %)
Installation/exchange of glow plugs
Requires a glow plug wrench (lug wrench SW 8, 9, 10 and 12).
Preheating the glow plug
A glow plug starter with rechargeable battery is placed on the glow plug and heats this so that the air-fuel mixture ignites and the engine starts. Once the engine
runs properly, the glow plug starter can be removed.
c) Tools and Aids
Prior to the start, you have to make and check a few basic settings as well as provide the necessary accessories and operating materials.
Go through the various points of the check list one by one; afterwards, your model is then ready to run.
Tools
• Socket wrench for the wheel nuts 7mm
• 5mm and 5.5 mm flat spanners to set alignment and inclination
• 1.5 mm Allen key for the grub screws on the adjusting rings of the throttle/brake and steering linkages
• Phillips screwdriver
• Normal screwdriver for the throttle stop screw and the main nozzle needle
Auxiliary materials
• Cable clips
• Air filter oil
• After Run oil
36