Tractel FABA-Klassik A11 514208 Instructions D'emploi Et D'entretien page 25

EN
FABA™ system components
1. Entries and exits
These enable you to leave the climbing
protection system at the stipulated
positions.
Removal
- Move the slider to the turnable rail
section.
- Pull the rear ratchet knob.
- Turn the rail section to the right
and remove the slider.
- Turn the rail section back until it
automatically locks into the vertical
position.
Insertion
- Pull the rear ratchet knob.
- Turn the rail section to the right.
- Insert the fall arrest slider into the
rail section.
- Turn the rail section back until it
automatically locks into the vertical
position.
2. Permanent catches
These prevent you from exiting the
climbing protection at the ends of the
climbing path (including horizontal
sections) and at gates. They may not
be removed.
3. Detachable catches
These prevent you from accidentally
leaving the climbing protection. It is
possible to deliberately detach yourself
from the system after opening the
catch, but this is only permitted if you
have previously taken other safety
precautions against falling.
Activation
- Turn the star knob next to the rail
so that the catch releases the path
in the rail.
4. Resting platform
You can pass by the resting platform
when the access fl ap is folded up. You
can fold the access fl ap down and use
it as a resting platform if necessary. If
the resting platform is used as a stan-
ding location from which other work
will be carried out, then the user must
also safeguard himself against falling
using an additional safety device that
is independent from the guided type
fall arrester.
Activation
- To fold out, fold each half of the
platform to the side and front until
they rest on the rung.
- To fold in, fold each half of the
platform upwards to the rear be-
hind the rail.
Maintenance
The FABA™ fall protection device is vir-
tually maintenance-free. The fall arrest
slider should be cleaned, if necessary,
with a dry or moistened cloth after
being used and left to dry before being
put away. Do not leave it out to dry in
the sun or in the vicinity of an open
fi re or not anywhere where it might be
aff ected by heat.
If the slider needs to be disinfected,
please contact TRACTEL Greifzug
GmbH for further information.
Storage
The FABA™ fall arrest slider must
be stored at temperatures between -30
°C and +60 °C when it is dry and pro-
tected against atmospheric conditions
and aggressive materials.
25