Publicité
Les langues disponibles
Les langues disponibles
•
To prevent unintentional verticutter start-up, the
2-point safety switch is fitted with a safety button
(pic. 1/2 or pic. 2/2) that must be pressed before
the switch lever is released (pic. 1/1 or pic. 2/1).
•
When releasing the switch lever the button must
be in the original position.
•
Make sure the extension cable is not within reach
of steel springs. Press the safety switch and pull
in the switch lever (pic. 1/1 or pic. 2/1).
•
To make sure everything works properly, this step
needs to be repeated several times before
aerating.
WARNING!!! You must necessarily wait
until the steel springs stop rotating and are idle for
any adjustment, servicing or repairs of your
verticutter/aerator. The verticutter must
necessarily be unplugged before these works.
Operation and adjusting
Adjust the appliance only when unplugged,
otherwise a high risk of injury will be faced.
Aerating
•
Select the working height appropriate for the
actual grass height.
•
Prevent a situation when the extension cable
cannot move freely
(pic. 4/F).
•
Move the appliance at appropriate speed. Do not
move it too fast to prevent the ejection hole from
getting blocked and engine from useless
overloading.
•
Never work with the appliance when raining and
on wet grass.
Servicing and treatment
Unplug the appliance before any servicing and
treatment! Service the appliance at regular intervals
(depending on the frequency of using). Servicing needs to
be strictly documented.
•
Make sure all the fastening elements (screws,
nuts, etc.) are always tightened to ensure safe
work with the verticutter.
•
Check the collection container more frequently for
signs of wear.
•
Check the appliance regularly and replace any
worn-out or damaged parts.
Cleaning
Keep the guards, ventilation slots and engine case with no
dust and dirt if possible. Wipe the appliance with a clean
cloth or blow it with compressed air under low pressure.
Cleaning the appliance immediately after each use is
recommended. Clean the appliance regularly with a wet
cloth and some liquid soap. Do not use cleaning agents and
solvents as they could damage the plastic parts of the
appliance. Make sure no water gets inside the appliance.
12
Publicité
