Table des Matières
Publicité
INSTALLA TION INSTRUCTION
BEFORE INSTALLATION
Testrun the unit with proper power supply. Refer to the
operation instruction section in the Owner's Manual
Operation & Installation. Make sure all the controls
operate correctly then disconnect the power supply
of the unit.
● Before installation, please check whether the unit is assembled
with three pieces of rubber pads and square sealing strip.
Moving parts may cause personal injury. Be careful when test the unit. Do not operate the unit
with exterior cover removed.
STEP 1-SELECTING AN INSTALLATION LOCATION &
INSTALLING THE ROOF TOP AIR CONDITIONER
Your air conditioner has been designed for use in recreational vehicles.
Check the roof of the vehicle to determine if it can support both the roof top unit and the ceiling
assembly without additional support. Make sure the interior ceiling mounting area will not
interfere with existing structures.
Once the location for your air conditioner has been determined. A reinforced and framed roof
hole opening must be cut (if there is no hole) or you may use existing vent holes.
CASE A.
If a roof vent is already present in the desired mounting location for the air conditioner, the
following steps must be performed:
1.
Remove all screws which secure the roof vent to the vehicle. Remove the vent and any
additional trim. Carefully remove all chalking from around the opening so the surface is
clear.
2.
It may be necessary to seal some of the old roof vent mounting screw holes which may
fall outside of the air conditioner basepan gasket.
3.
Examine the roof opening size, if the opening is small than 356x356mm, the opening
must be enlarged. If the opening exceeds 356x356mm, a mounting plate (frame) must
be fabricated to reduce the opening size (See Figure 1).
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
WARNING
!
- 15 -
Publicité
Chapitres
Table des Matières
Dépannage
