Gree GRH085DA-K3NA1A Manuel D'utilisateur page 17

Note: If the remote controller is missing, operate on the control panel.
2
ON/OFF button
1
Operation starts when pressing this button, and
stops when pressing this button again.
SWING button
2
Activate the automatic air swing function.
FAN SPEED button
3
Select the fan speed LOW, MED, HIGH and TURBO
in sequence.
(+/-) / WIFI button
4
Press the + button to increase the set(operating)
temperature of the unit,and press the - button to
decrease the set(operating) temperature of the
unit. the temperature setting range is from 16~30℃
o
(61~86 F).
Press WIFI button to turn on or turn off WIFI
function. When WIFI function is turned on, the
wifi light will be displayed. (The function only
applicable for some models. )
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
CONTROL PANEL
GRH085DA-K3NA1A(WIFI)
GRH120DA-K3NA1A (WIFI)
TURBO
HIGH
MED
LOW
6
3
WIFI
4
MODE button
5
Select the operation mode, COOL, DRY,
FAN, HEAT (for heat pump model) or
COOL, DRY, FAN (for cooling only model).
FILTER CHECK button
6
This feature is a reminder of cleaning the air
filter(normal maintenance) for more efficient
operation. The light will turn on automatically
after the fan works more than 250 hours.
If the light is on, turn off and power off the
unit, take the air filter out and clean it, then
re-install the air filter, power on and turn
on the unit, the light will still be on, press
FILTER CHECK button,the light will
turn off.
- 14 -
1
4
Not available for
cooling only model
5