Leak Out Time (Menu 3.13) - Animo ComBi line CB 5 Mode D'emploi

12.4.10 1 st charge (menu 3.12)
The 1 st charge volume can be increased if it is only found out
later in practise that the filtering process threatens to overflow
Setting the 1 charge volume
st
• The 1 st charge volume only becomes active if the
interval is set at 95% or less.
• The 1 st charge volume is set for half way through the
brewing process as standard.
• The 1 st charge volume can be set according to the
following overview (Table 7).
Set the desired 1 st charge volume and confirm your changes
with the START button
changes using the STOP button
Standard
Model 1 st charge
CB 5 2.500 ml
CB 10 5.000 ml
CB 20 10.000 ml
Table 7. 1 charge volume settings scope
st
12.4.11

Leak out time (menu 3.13)

The leak out time starts once the hot water distribution is
stopped. The leak out time through the filter can vary
depending on the type, size and/or amount of coffee.
Leak out time settings
• If no leak out time is required the time can be set to 0.
There will then be no dripping symbol in the display
followed by a sound signal.
Set the required leak out time and confirm your changes with
the START button or go back without saving any changes
by pressing the STOP button
Standard
Model leak out time
CB 5 240 sec
CB 10 300 sec
CB 20 360 sec
Tabel 8. Leak out time
ComBi line
or go back without making any
.
Settings scope
2500 - 4500 ml
5000 - 9000 ml
8000 - 18.000 ml
.
Settings scope
0 - 900
0 - 900
0 - 900
1e charge volume (CB5W)
Step
250
250
250
Step
10
10
10
78
Leak out time
Fig. 31
Fig. 32
03/04