Mounting The Dwi On A Wall - Animo ComBi line CB 5 Mode D'emploi

3.6

Mounting the DWI on a wall

Mount the appliance on the wall with the aid of the bracket
supplied in accordance with the condition of the mounting wall and
with the aid of suitable plugs. In case of cellular concrete,
plasterboard or similar walls of other materials screw right through
them or apply extra wall reinforcement.
1. The local voltage should correspond to the specifications
indicated on the type plate.
2. Determine the complete arrangement of the serving trolley(s)
with flow water heaters.
3. Determine position of the flow water heater, see the figure
alongside.
4. Mount the flow water heater to the wall with the aid of the
bracket supplied and connect electricity, water supply and
overflow pipe.
5. Position the serving trolley, container and filter next to the
flow water heater (take the parking rails into account see
point 6), adjust the stop of the swivel arm in such a way that
the outlet is always above the centre of the filter. The stop
can be reached by pulling the swivel arm up vertically.
6. Take note! the swivel arm should always be at a slight
downward angle.
7. Determine the place of the parking rails and mount them on
the wall at the correct height in such a way that the serving
trolley will stand with its round push rubbers in between the
parking rails.
8. Attach the drip tray to the to the bracket with the aid of the
supplied side strips.
NOTICE
If only one serving trolley is placed next to the flow water heater,
we recommend you to adapt the swivel arm protection (located
under the swivel arm) on the side on which no serving trolley is
placed. This prevents the possibility of starting the flow water
heater when the swivel arm is in the opposite direction to the one
where the serving trolley is placed The adaptation is done as
follows.
1. Remove the swivel arm by lifting it vertically out of the flow
water heater.
2. Detach the relevant stop from the swivel arm bottom.
3. Remove the magnet from the underside of this stop.
4. Reassemble the stop on the bottom.
5. Place the swivel arm back on the flow water heater.
6. Test whether the flow water heater can only be activated
when it is above the filter.
The supplier cannot be held liable for any
consequences arising from failure during installation
of the appliance according to the instructions.
03/04
51
90˚
CB with serving trolley
ComBi line