Starting The Coffee Maker Descaling Program (Menu 1.1) - Animo ComBi line CB 5 Mode D'emploi

12.2.2 Starting the coffee maker descaling
program (Menu 1.1)
This is where you start the descaling program for the coffee
maker.
Preparation
- Move the swivel arm above an empty container
and synthetic filter.
- Brew the smalles brewing amount (without coffee) once.
The advantage of this is that the element is well
preheated, so that descaling is better and takes less
time.
- Carefully read the caution notice and the directions on
the sachet Animo scale remover.
- Dissolve 2 sachets of 50 gram Animo scale remover
into 2 litre of warm water (60°C). Stir the solution
thoroughly so that the powder is completely dissolved.
- Remove the filter and place a plastic container under the
outlet of the swivel arm to collect the scale remover.
- Follow the instructions shown on the display and confirm
each action with
Stopping the program?
The program can be cancelled at any time until the solution
is poured in. Once the solution has been poured in, the program must
always be completed. In case of an emergency stop, the STOP
button can always be used. The program will then stop, but not be
finished.
Display: 1/5 Place measuring cup. Press start
Once the container is empty press the START button
Display: 2/5 <- funnel left. Pour solution through. Ready?
Press start .
- Remove the cap from the descaling opening left of the
swivel arm (fig. 1-7).
- Insert the descaling funnel (fig. 17A) into the descaling
opening. Push the funnel downward as far as possible.
- Slowly pour the scale remover into the funnel.
The scale remover will enter the boiler element by the
supply pipe and will come out of the swivel arm as foam.
- The descaling solution can be poured into the funnel a
second time after it has been collected in the plastic
container. As long as the scale remover comes out of
the swivel arm foamingly, there are scales deposits in
the appliance. Repeat the procedure described above
with a new solution until no more foam comes out of the
swivel arm.
- Press the START button
03/04
.
.
to continue the programm.
Start descaling program
.
A
Descaling procedure
69
coffee maker
Ltr 2,2
2200 ml
2000
1800
1600
1400
1200
1000
800
600
400
200
ComBi line
Fig. 16
Fig. 17