Switching On The Container Heating Automatically (Menu 3.8); Coffee Making Descale Indicator Settings (Menu 3.9) - Animo ComBi line CB 5 Mode D'emploi

Factory
Model settings
CB 5 4-12-16-20
CB 10 10-20-30-40
CB 20 20-40-60-80
Table 4. Selection buttons unit jugs
12.4.6 Switching on the container heating
automatically (menu 3.8)
When starting a coffee making process the appliance
automatically switches the right container heating on.
The container heater then stays switched on and must always
be switched off manually. You can switch this function off if
required. See fig. 27.
Select the required choice and confirm your changes with the
START button or go back without saving any changes by
pressing the STOP button
12.4.7 Coffee making descale indicator settings
(menu 3.9)
Before you start using the appliance you must first set the
descale indicator.
• The default descale indicator is set to 1000 litres
(average water hardness) and has a scope of 0 to 9999
litres in steps of 100
• Use the table 5 below and select the relevant water
hardness in the left column (°D). On the right you can
read after how many litres (recommended) the system
must be descaled.
• Once the set amount of litres has been reached a
spanner symbol will appear in the display. The appliance
will continue to work normally so that descaling can be
done at a more suitable time.
• In the Descaling menu 1.0 you can see how many litres
away from a descale indicator signal the system still is.
Water
quality
Very hard 18-30
Hard 12-18
Average
Soft
Very soft
Table 5.
03/04
Settings scope
jugs = 250 ml
jugs
4-20
jugs
8-40
jugs
16-80
.
Hardness
°D °F mmol/l
32-55 3,2-5,3
22-32 2,2-3,2
8-12 15-22 1,4-2,2
4-8 7-15 0,7-1,4
0-4 0-7 0-0,7
Water hardness
Step
1 jug
1 jug
1 jug
Auto container verwarming
Descale
indicator
mgCaCo3/l
litres
321-536 250
214-321 500
268-214 1000*
72-268 1500
0-72 2000
* Standard settings
75
Coffee making descale
indicator settings
Fig. 27
Fig. 28
ComBi line