Periodic Descaling Activities; Descaling The Coffee Maker; Temperature Protection; Transport - Animo ComBi line CB 5 Mode D'emploi

7.2

Periodic descaling activities

This chapter describes the periodic descaling activities of the machine that can only be executed by trained,
qualified personnel.
WARNING
• Observe the descaling intervals indicated by the descaling indicator symbol.
• Overdue maintenance to the heating system can result in high repair costs and annulment of the guarantee.
• Always follow the manufacturer instructions when using the scale remover.
• Do not leave the appliance unattended when maintenance is being performed.
• When descaling the appliance, it is advisable to wear safety glasses and protective gloves.
• Wash your hands after descaling.
7.2.1

Descaling the coffee maker

After entering the Operator PIN you have access to the descaling menu where you can start the descaling
program for the coffee maker. Follow the descaling procedure as described in chapter 12.2.2 of the operator
menu.
8.

TEMPERATURE PROTECTION

There temperature protections in the unit (fig. 1-5) that can be accessed from the outside.
These protection switch off the temperatures rise too high. The most common cause for switching off is scale
that has not been removed in time. If the temperature protection operates proceed as follows:
1. Let the unit cool down.
2. Unscrew the black protection cover.
3. Push the button that now appears and replace the black cover tightly.
When the protection was triggered due to scale formation, then proceed according to section 12.2.
When scale formation was not the cause, then contact your dealer.
9.

TRANSPORT

If the machine has to be transported, the water reservoirs must be emptied.
1. Switch the appliance off and remove the plug from the wall socket.
2. Remove the plugs from the containers and remove the containers.
3. Close the water outlet tap and disconnect the supply and overflow hoses.
4. Take the drain hose tap (fig. 1-8) out of the underside of the base plate, to drain the flow heater system
completely, then close it off again. (Attention: the water can still be hot!).
5. The unit is now ready for (upright) transportation.
6. Proceed with section 3-INSTALLATION to reinstall the appliance.
03/04
63
ComBi line