Safeguards; Appliance And The Environment - Animo ComBi line CB 5 Mode D'emploi

Safeguards

The appliance is fitted with the following safeguards:
On/off switch (fig. 1-2)
The on/off switch is used to switch the appliance on and off. Remember that the appliance can still be live after
being switched off! For this reason you should always remove the plug from the socket to render the appliance
voltage-free.
STOP button (fig. 1-4.1)
The coffee making process can be interrupted at any point using the STOP button located on the control panel.
Swivel arm and container detection
This appliance is equipped with a safety device through which it is only possible to start the brewing process if the
swivel arm and container are in the correct position. If the swivel arm and/or container are moved out of position
during the brewing process, the brewing process is interrupted, a swivel arm and/or container symbol appears in
the display and there is a sound signal (2x short). Once the positioning fault has been resolved the brewing
process can be restored by pressing the START button.
Dry-boil protection
This appliance is equipped with a dry-boil protection. This protection triggers if the heating elements overheat
owing to a fault. Once the fault has been resolved, the dry-boil protection can be reset at the outside of the
appliance. The most common cause of the dry-boil protection being triggered is not descaling the heating system
in time.
Warning indication display
A technical fault is reported by displaying an error code in the display. The relevant problem can be localised and
resolved with the help of this code. In this case see chapter 13-TROUBLESHOOTING.
Appliances and the environment
The packing material
Your new coffee maker has been carefully packaged to protect it against damage.
The packing is not harmful to the environment and consists of the following materials:
• Corrugated cardboard.
• Filler elements made of polyurethane foam <PUR> covered with a polythene film (>PE-HD<).
The waste processing plant in your municipality will be pleased to inform you where you can dispose
of the materials.
Discarding the appliance
No appliance lasts forever. When the time comes to discard your appliance it will usually be possible to return it
to your dealer. If this is not the case, ask your municipal council about the alternatives for recycling the materials.
All plastic parts have been given standard codes. The parts of the appliance such as the printed circuit board and
accompanying parts form electrical and electronic waste. The metal body is made of stainless steel and can be
completely dismantled.
03/04
45
ComBi line