Unit (Menu 3.1); Cup Volume (Menu 3.2) - Animo ComBi line CB 5 Mode D'emploi

12.4.1 Water volume (Menu 3.0)
WARNING
• The container will overflow if too large an amount is set.
• The manufacturer accepts no responsibility for the
consequences of changed settings.
During use, it can occur that the quantity of water in the
container is not as required. This depends on the amount of
coffee and the size of coffee ground used. The amount of
water that comes out of the swivel arm is set to 6% - 10%
extra water as standard. Table 1 shows the settings scope.
Factory-
Model settings
CB 5 5.300 ml
CB 10 10.800 ml
CB 20 22.000 ml
Table 1. Water volume
Increase or decrease the water volume [ml] with the selection
buttons above and below the display.
Confirm the changes made with START button
without making any changes by pressing the STOP button

12.4.2 Unit (Menu 3.1)

You can change the unit in which the selection buttons are
shown in the display with this function.The unit can be set as
Litres (standard), Jug or Cup.
Select the required unit and confirm your changes with the
START button or go back without saving any changes using
the STOP button .
Please note: The counter menu continues to be displayed in
litres.

12.4.3 Cup volume (Menu 3.2)

You can change the volume of the cup with this function.
The cup volume is set to 125 ml as standard
The settings scope is between 100 and 500 ml (1 ml steps).
Set the required cup volume and confirm your changes with
the START button or go back without saving any changes
by pressing the STOP button
03/04
Settings
4.800-5.800 ml
9.800-11.800 ml
20.000-24.000 ml
or go back
.
Change volume of water
.
Change cup volume
73
Fig. 21
Unit Fig. 22
Fig. 23
ComBi line