Identification; Maintenance Manual; Handling - Gaspardo PINOCCHIO 130 Manuel D'emploi Et Entretien

1.4 IDENTIFICATION

Each single piece of equipment, is equipped with an identification
plate, which bears:
1) Mark, name, business name and address of the Manufacturer;
2) Type;
3) Mass of the equipment, kilograms;
4) Useful mass, kilograms;
5) Serial number;
6) Year of manufactured;
7) CE mark.
Write your data on the serial number plate below together with the
purchase date (8) and dealer's name (9).
This information must always be quoted whenever assistance or
spare parts are needed.
ATTENTION
Do not remove, tamper with or render illegible the machine's CE
mark.
ATTENTION
Refer to the data contained on the machine's "CE" mark for all con-
tact with the manufacturer (e.g.: for requesting spare parts etc.)
ATTENTION
When the machine itself is demolished, the CE mark must be
destoyed.

1.4.1 MAINTENANCE MANUAL

The manual must be kept in perfect condition for the entire life of
the machine, right up to the time when it is demolished (see chapter
5 DEMOLITION AND DISPOSAL).
In the event of transfer, sale, hire, licence to use or leasing of the
equipment, the present manual must accompagny it at all times.
cod. R19502010
USE AND MAINTENANCE
(2)
(3)
(5)
(7)
Fig. 2

1.5 HANDLING

If the machine is handled, it must be lifted by hooking onto the
appropriate holes with a suitable winch or crane of sufficient ca-
pacity. Due to the dangerousness of this operation, it should only
be performed by skilled and expert personnel.The mass of the
machine is on the identification Plate (5 Fig. 1).
The hook points can be detected by finding the «hook» symbol
(6 Fig. 2).
The machine's handling operations should be carried out by
one operator only.
The operator must ensure that there are no third parties near
the machine or in the area in which manoeuvres are being
carried out.
If the machine is lifted using a block and tackle or similar
equipment, do not stand underneath the suspended load.
Lift the machine, keeping it as near the ground as possible.
When lifting the machine, use only the hooking points indi-
cated in this manual.
Working overalls, safety footwear and safety gloves must be
worn.
ENGLISH
(1)
(4)
(6)
(8)
(9)
ATTENTION
ATTENTION
ATTENTION
ATTENTION
ATTENTION
ATTENTION
27