Information On Free Standing Gas Ranges; Laws, Regulations And Technical Directives; Place Of Installation; Positioning - Diamond G4SF Mode D'emploi

2.1

INFORMATION ON FREE STANDING GAS RANGES

This booklet applies to our gas range type A1 Category II (Natural Gas and L.P.G.).
See table 1.1.
The plate according to EN437 and EN 203-1-2 is on the back and inside.
Example of Italian plate: Cat. II 2H3+
Pe = Incoming pressure
Pi = Nozzle pressure
REA 16238T4 ITALY
2.2

LAWS, REGULATIONS AND TECHNICAL DIRECTIVES

The following regulations must be observed during installation:
- Current accident and fire regulations.
- The regulations of the gas supply company, which has to issue an authorization before installation.
- "Gas system installation" standards.
- "Electric system installation" standards.
- The regulations of the electric power supply company.
- Health regulations.
2.3

PLACE OF INSTALLATION

- The unit should be installed in a room with adequate ventilation. This unit requires a draft of at least 2 m
(Thermal Capacity).
- Install the unit in compliance with the safety regulations UNI - CIG 8723, law No. 46 dated 5-3-'90 and Italian Ministerial
Decree D.M. No.74 dated 12.04.96.
2.4

POSITIONING

- The various units may be installed separately or combined with other units in our range.
- This unit is not suitable for encasing.
- The distance from the side walls must be at least 10 cm.; should the distance be less or the material of the walls or floor be
flammable, it is vital to install thermal insulation.
- The unit needs to be supplied with gas with the characteristics and pressure shown in Table II.
20,37,50
Mod. SN°
Made by
HU
Cat.
II
2HS3B/P
Pn (mbar)
25,25,30/30
G 20
G 25.1
MK
Pin.N°
Hz
kW
Type
G 30
G 31
- 17 -
3
/h • kW T.C.
GB