Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Safety
INSTALLATION
7.
Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1
General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
7.2
Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
8.
Appliance description
8.1
Standard delivery
The following are delivered with the appliance:
- Wall mounting bracket
- 5 mm spacer (2 pce for above, 2 pce for below)
- Caps (2 pce)
- Installation template
8.2
Accessories
Required accessories
Various safety assemblies are available that need to be selected
subject to the static pressure. These type-tested safety assemblies
protect the appliance against impermissible excess pressure.
Further accessories
The load shedding relay activates the priority control during oper-
ation of the appliance when you are simultaneously operating an-
other appliance, such as an electric storage heater (for connection,
see chapter "Specification / Wiring diagrams and connections").
20
| SHD
9.
Preparations
9.1
Installation site
The appliance is designed for installation on a solid wall. Ensure
the wall offers adequate load bearing capacity.
Install the appliance vertically in a room free from the risk of frost
and near the draw-off point.
9.2
Fitting the wall mounting bracket
f You can use the installation template to transfer the dimen-
f
sions to the wall.
f Drill the holes and secure the wall mounting bracket with
f
screws and rawl plugs. Select fixing materials in accordance
with the wall construction/condition.
You can compensate for unevenness in the wall with the spacers
provided.
1
2
1 Upper spacer
2 Lower spacer
9.3
Preparing the power cable
120
270
www.stiebel-eltron.com
Publicité
Chapitres
Table des Matières
Dépannage
