Control Panel And Oven Doors - La Cornue AlberTine 90 Mode D'emploi

Stainless Steel Main Top
Lift away pots or pans from the main top. Remove grates
from spillage area and carefully place in a sink of warm
soapy water. Wipe loose debris from main top. Avoid using
any abrasive cleaners including cream cleaners on brushed
stainless steel surfaces. For best results use a liquid detergent
cleaner. Rinse with cold water and thoroughly dry with a
clean, soft cloth. Ensure all parts are dry before repositioning.
Griddle (optional extra)
Always clean the griddle after use. Allow to cool completely
before removing. Immerse the griddle plate in hot soapy
water. Use a soft cloth or, for stubborn stains, a nylon washing
up brush.

Control Panel and Oven Doors

Avoid using any abrasive cleaners including cream cleaners,
on brushed stainless steel surfaces. For best results use liquid
detergents.
The control panel and control knobs should only be cleaned
with a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance. Wipe
with a clean dampened cloth then polish with a dry cloth. The
oven doors should only be cleaned with a soft cloth wrung
out in clean hot soapy water.
Removing the Oven Linings
Remove the shelves first. To remove the oven shelf supports
lift until clear of the two supporting holes and pull outwards
(Fig.6-4).
Note: There are specific liners for the left and right hand sides.
To remove the side panels, simply lift the panel and slide
forwards.
Replacing the Oven Linings
To replace the liner the cut-out section must be at the top of
the liner. Slide the liner towards the back of the oven cavity.
When this is in place the shelf supports can be replaced. To
do this, first insert the bottom of the support in the cut-out
followed by the two hooks at the top (Fig.6-5).
�������������������������������������������
���������������������������������
15
Fig.6-4
Fig.6-5