Positioning The Cooker; Unpacking The Cooker; Removing The Oven Door - La Cornue AlberTine 90 Mode D'emploi

Fig.7-1
ArtNo.280-0024 - 110 Position 1 USA
ArtNo.280-0025 - 110 Position
Fig.7-2
Fig.7-3
ArtNo.341-0001 - 90SC - Drawer pulled forward
Fig.7-4
ArtNo.280-0027 - Drawer clip lift 90
ArtNo.281-0017 - Removing the door
Fig.7-5

Positioning the Cooker

The diagrams show the minimum recommended distance
from the cooker to nearby surfaces (Fig.7-1 and Fig.7-2).
The cooker should not be placed on a base.
Above hotplate level a gap of 75mm should be left between
each side of the cooker and any adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles) this can be reduced to 25mm.
Adjacent work surfaces should be level with or below the
hotplate surround not the pan supports.
We recommend a gap of 905mm between units to allow for
moving the cooker. If a flush fit is required, fit the cooker up
to the unit at one side then fit the unit the other side. Do not
box the cooker in; it must still be possible to move the cooker
in and out for cleaning and servicing.
A minimum space of 800mm is required between the top of
the hotplate and a horizontal combustible surface.
Any cooker hood should be installed in accordance with the
hood manufacturer's instructions.
For safety reasons curtains must not be fitted immediately
behind the cooker.
If the cooker is not installed between units, a side panel
extension that closes the gap to the wall at the rear, is
available as an optional extra kit.

Unpacking the Cooker

Do not take any packaging off the cooker until it is directly
in front of the place it is to be installed (unless it will not fit
through a door in its outer packaging).
Pull the drawer out to its furthest point (Fig.7-3).
Lift up the ends of the plastic clips (one each side) to release
the catches holding the drawer to the side runners and at the
same time pull the drawer forward and away from the side
runners (Fig.7-4).
For safety's sake push the drawer runners back out of the
way. Put the drawer some where safe – do not refit it until the
installation is complete.

Removing the Oven Door

To remove the door, open the door fully. Swivel the locking 'U'
clips forward to the locking position (Fig.7-5). To remove the
oven door, grip the sides of the door, lift upwards and then
slide the door forwards (Fig.7-6).
When you have removed the oven door continue as follows:
Now lower the two rear rollers.
First use the levelling tool to turn the hexagonal adjusting nut
as shown below.
Make 10 complete (360°) turns clockwise – this means turning
and removing the levelling tool 20 times (Fig.7-7).
18