Fitting The Plinth - La Cornue AlberTine 90 Mode D'emploi

Fig.7-16
ArtNo.280-0048 Handrail Parts
Fig.7-17
ArtNo.280-0051 Handrail Fitting Endcaps C
Fig.7-18
ArtNo.280-0053 Door Knob Screw to Door
Fig.7-19
Fig.7-20
ArtNo.341-0001 - 90SC - Drawer pulled forward
ArtNo.341-0003 - Drawer locking
ArtNo281-0026 Front Plinth
Assembling the Loose Parts
Fitting the handrail
The hand rail is supplied as 2 end pieces with grub screws, 2
plastic friction cups and the rail tube (Fig.7-16).
Hold a friction cup by the tabs on one end of the tube. Fit one
of the end pieces to the tube and push it on the tube over the
friction cup (Fig.7-17).
Turn the tube over and fit the other end piece using the
second friction cup, making sure that you do not scratch or
damage the first end piece and the that the two end pieces
are lined up correctly.
Fit the assembled hand rail to the projecting mounting studs
on the control panel and fix it in place by tightening the grub
screws. The grub screws should be on the underside.
Fitting the Door Handles
Fit the door knobs to door knob bases and screw them on to
the mountings on the oven doors. Hand tighten only - do not
use any tools (Fig.7-18).

Fitting the Plinth

Remove the 3 screws for the plinth mounts along the front
bottom edge of the range (Fig.7-19). Fasten the plinth using
these screws (alternative colour screws can be found in the
loose parts pack).
Refit the Drawer
Rest the drawer back on the side runners and, keeping it level,
push it right back. The clips should click into position holding
the drawer to the side runners (Fig.7-20).
Refitting the Oven Door
To refit the door, slide the hinges back into their slots. Rotate
the locking 'U' clips back to fit onto the hinges.
Customer Care
Please inform the user how to operate the cooker. Place
these instructions into the coloured CornuFé folder in the
instruction pack and hand them to the user.
Thank you.
22