Fitting The Flue Grille - La Cornue AlberTine 90 Mode D'emploi

Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the range.
Note the rollers are only intended to aid installation - the
range should not be moved once it is installed.
Push the range close to its final position, leaving just enough
space to get behind it (Fig.7-8).
The appliance can be lifted/moved by gripping the top of the
oven cavity once the door is removed.
Do not replace the storage drawer yet.
IMPORTANT: Remove all tape and packaging. Make sure
the burner heads are properly seated and level. Take the
accessory pack out of the oven. Check to be sure that no
range parts have come loose during shipping.

Fitting the flue grille

The flue grille is packed separately (Fig 7-9).
The larger of the holes along the sides are for screwdriver
access and should face to the rear. Use the screws and nuts
supplied to fix the grill in place (Fig 7-10).
Clip the flexible extensions of the oven flues to the flue grille
using the clips provided inside the flue grille.
Levelling
It is recommended that you use a spirit level on a shelf in the
oven to check for level.
Place the cooker in its intended position. Take care not
to twist it within the gap between the kitchen units, as
otherwise, damage may occur to the cooker or units.
The front feet and rear rollers can be adjusted to level the
cooker. To adjust the height of the rear of the cooker, use the
levelling tool supplied to turn the roller adjusting nuts at the
front bottom corners of the cooker. To raise of lower the feet,
simply turn the disks that are fitted onto them.
�������������� � �� ���� �������� ��� ����
x10
ArtNo.010-0009 Pushing the cooker
ArtNo.280-0029 - Flue Grill
ArtNo.280-0030 - Fixing Flue Grill
19
ArtNo.010-0003 Lowering the rear rollers
Fig.7-6
Fig.7-7
Fig.7-8
Fig.7-9
Fig.7-10