Motor Replacement; Control Board Replacement; Remote Battery Installation - Napoleon NEFB33H Instructions D'installation Et D'opération

22
6.4

MOTOR REPLACEMENT

A. To access the 2 screws holding the motor, remove
the refl ector. Pull the refl ector out from the adaptor
EN
to release the refl ector and pull the adaptor from
the motor.
B. Unplug the quick connect motor wire from the wire
harness.
C. Remove the 2 screws holding the motor and take
the motor out of the unit.
6.5

CONTROL BOARD REPLACEMENT

A. To prevent stripping of the plastic plugs on the back of the control board, hold the plugs with pliers
while removing each of the 4 screws.
B. Unplug all the wires connected on the control board.
6.6

REMOTE BATTERY INSTALLATION

1. To replace the existing battery remove the
battery holder.
2. To remove the battery holder turn remote
onto front side and press the left side leaver
towards the center while pulling the battery
holder out using the slot provided.
3. Replace existing battery, type CR 2025,
with a new battery and reinstall the battery
holder into the remote by sliding it
into position, as shown.
4. Battery holder is secure into the remote
control when a "CLICKING" noise is heard.
W415-2165 / E / 02.23.17
ADAPTOR
REFLECTOR
BATTERY (CR 2025)
BATTERY HOLDER
MOTOR
REMOTE
(REAR SIDE)