Napoleon NEFB33H Instructions D'installation Et D'opération page 15

A. Remove the securing screw from the electrical cover plate, located on the right hand side of the
fi replace.
B. Add an electrical box connector and feed the supply wires through the 7/8" (22mm) knock out.
C. Separate the black, white, red and green wires that have the wire nuts on them.
D. Remove the wire nuts and secure the black wire (L1) to the black (L1) lead of the power supply.
Connect the red wire (L2) to the red wire (L2) of the power supply. Connect the white wire from
the unit to the white (N) wire from the power supply. Connect the green wire to the ground wire.
E. Resecure the cover plate.
F. Locate the voltage selector switch inside the appliance. Remove the 2 screws on the metal
cover.
G. Ensure that the switch is switched to 240 volt position (230 is printed on the switch). Reinstall the
metal cover.
BLACK
RED (L2)
WHITE
GREEN
NOTE: To aid with moving the appliance, leave enough wire so that the appliance can be removed
from the enclosure without disconnecting the power supply. If servicing, shut off power supply.
(L1)
(N)
(G)
WIRE NUT
240V
BLACK (L1)
RED (L2)
WHITE (N)
(G)
GREEN
W415-2165 / E / 02.23.17
15
EN