Napoleon NEFB33H Instructions D'installation Et D'opération page 13

A. Remove the securing screw from the electrical cover plate, located on the right hand side of the
fi replace.
B. Add an electrical box connector and feed the supply wires through the 7/8" (22mm) knock out.
C. Separate the black, white, red and green wires that have the wire nuts on them.
D. Remove the wire nuts and secure the black wire (L1) to the black (L1) lead of the power supply.
Connect the white wire and red wire from the unit to the white (N) wire from the power supply.
Connect the green wire to the ground wire.
E. Resecure the cover plate.
F. Locate the voltage selector switch inside the appliance and remove the 2 screws on the metal
cover.
G. Ensure that the switch is switched to 120 volt position (115 is printed on the switch). Reinstall the
metal cover.
BLACK
RED (L2)
WHITE
GREEN
NOTE: Leave enough wire so that the appliance can be removed from the enclosure without
disconnecting the power supply.
(L1)
(N)
(G)
WIRE NUT
120V
BLACK (L1)
WHITE (N)
(G)
GREEN
W415-2165 / E / 02.23.17
13
EN