Operating Instructions; Operating Control Panel - Napoleon NEFB33H Instructions D'installation Et D'opération

16

4.0 OPERATING INSTRUCTIONS

Once the appliance has been plugged into a grounded electrical outlet or hard wired to a dedicated 120V or
EN
240V power supply, it is ready to operate.
NOTE: Ensure the house circuit breakers for the power supply are turned on.
4.1

OPERATING CONTROL PANEL

The Control Panel is located on the top front of the appliance.
POWER
FLAME & EMBER LIGHT
CONTROL
HEATER CONTROL
TIMER
DECORATIVE LIGHT
F° / C° SWITCH
HEATER LOCK
TEMPERATURE
CONTROL
W415-2165 / E / 02.23.17
Turns the appliance ON/OFF.
Controls Flame brightness and the Ember Light.
5 Settings: Flame & Ember off (FO), Ember and log on but
Flame off (LL), small Flame & Ember (F1), medium Flame
& Ember (F2), brightest Flame and Ember (F3).
Turns the Heater and Blower ON/OFF.
3 Settings: Heater & Blower off (HO), Blower on (BL),
heater and blower on (H1).
Timer can be programed to run appliance for specific
lengths of time (30mins. minimum to 6hrs maximum).
Controls Decorative Light settings.
4 Settings: Decorative Light off (do), white colour (d1),
auto-cycle from White / Orange / Blue / Orange-Blue /
White-Orange / White-Blue (d2), lock to desired colour
(d3). It will take 8.5 seconds to switch between colours
(on d2 setting).
Hold 5 To change temperature format, Fahrenheit or Celsius.
seconds
Press and hold the Flame button
Heater button can be locked or unlocked by holding the
Hold 5
Heater button for 5 seconds.
seconds
Press and hold the Timer button
Hold 5
will change the button to Temperature Control, or vice
seconds
versa. There are 7 temperature settings (61
75 F, 81 F, 85 F and OFF)
° ° °
for 5 seconds.
for 5 seconds. This
F, 64 F, 70 F,
° ° °