Glass Door Installation - Napoleon NEFB33H Instructions D'installation Et D'opération

5.2

GLASS DOOR INSTALLATION

IF EQUIPPED WITH DOOR LATCHES THAT ARE PART OF A SAFETY RELIEF SYSTEM, THEY MUST BE
PROPERLY ENGAGED. DO NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRE OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR SERVICE.
OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
A. To install the glass door, simply place the door on the holding pins on the bottom frame of the unit.
Install the screw into the safety catch wire, slightly push the glass door into the frame and latch it
secure with the two top latches.
B. To remove the glass door, swing the top two latches to release the door. The door will hang slightly
on the the safety catch wire. NOTE: Pushing in on the door will make the latch swing easier.
C. Place one hand on the glass door while removing the screw from the catch wire. Allow the door to
pivot slightly, hold the sides with both hands while lifting the door out of the unit.
OPEN
* ILLUSTRATED WITH LATCHES VISIBLE
!
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
LATCH
LOCK
PIN HOLE
WARNING
19
47.1
SAFETY
CATCH WIRE
SCREW
W415-2165 / E / 02.23.17
EN