Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Once the appliance has been plugged into a grounded electrical outlet or hard wired to a dedicated 120V power
supply, it is ready to operate.
ATTENTION: Ensure the house circuit breakers for the power supply are turned on. When initially
connecting the appliance into a power source the unit will perform an LED check. The unit will flash on
and off for 5 seconds.
3.1
operating control panel
The Control Panel is located on the top front of the appliance.
POWER
FLAME & EMBER LIGHT
CONTROL
HEATER CONTROL
TIMER
DECORATIVE LIGHT
(CEFB27/29H ONLY)
F° / C° SWITCH
HEATER LOCK
TEMPERATURE
CONTROL
3.0 operating instructions
Turns the appliance ON/OFF.
Controls Flame brightness and the Ember Light.
5 Settings: Flame & Ember off (FO), Ember on but Flame
off (LL), small Flame & Ember (F1), medium Flame &
Ember (F2), brightest Flame and Ember (F3).
Turns the Heater and Blower ON/OFF.
4 Settings: Heater & Blower off (HO), Blower on (BL), low
heat (H1), high heat (H2).
Timer can be programed to run appliance for specific
lengths of time (30mins. minimum to 6hrs maximum).
Controls Decorative Light settings.
4 Settings: Decorative Light off (do), white colour (d1),
auto-cycle from White / Orange / Blue / Orange-Blue /
White-Orange / White-Blue (d2), lock to desired colour
(d3). It will take 8.5 seconds to switch between colours
(on d2 setting).
Hold 5
To change temperature format, Fahrenheit or Celsius.
seconds
Press and hold the Flame button
Heater button can be locked or unlocked by holding the
Hold 5
Heater button
for 5 seconds.
seconds
Press and hold the Timer button
Hold 5
will change the button to Temperature Control, or vice
seconds
versa. There are 7 temperature settings (61
75
F, 81
F, 85
F and OFF)
°
°
°
operating instructions
for 5 seconds.
for 5 seconds. This
F, 64
F, 70
F,
°
°
°
W415-1662 / C / 07.20.20
EN
13
Publicité
Chapitres
Table des Matières
